Therm O Web HeatnBond UltraHold Iron-On Adhesive Tape, 5/8 in x 10 yds 3509.58
Therm O Web HeatnBond UltraHold Iron-On Adhesive Tape, 5/8 in x 10 yds 3509.58
Therm O Web HeatnBond UltraHold Iron-On Adhesive Tape, 5/8 in x 10 yds 3509.58
Therm O Web HeatnBond UltraHold Iron-On Adhesive Tape, 5/8 in x 10 yds 3509.58
  • SKU: 3509.58
  • Availability: in stock Many in stock Out of stock You can purchase this product but it's out of stock

HeatnBond UltraHold Iron-On Adhesive Tape, 5/8 in x 10 yds

$2.79
  • Barcode: 000943058106
HeatnBond UltraHold is a roll of paper backed, iron-on, no-sew, double-sided adhesive for bonding fabric without the need for pinning. UltraHold’s no-sew bond is stronger than traditional fusible webs.

Product Details

  • 5/8 in x 10 yards (15.9 mm x 9.1 m)
  • Heat activated
  • Permanent
  • Double-sided adhesive
  • Solid sheet adhesive on a paper backing
  • For use on fabric
  • No sewing needed!
  • Acid-Free
  • Proudly made in the USA

Video

General Directions

  1. Pre-wash all materials without fabric softeners. Pretest adhesive on materials before starting project.
  2. Preheat iron to medium heat, no steam. Place adhesive on the (wrong side) back of material to be bonded (paper liner should face up).
  3. Place and hold iron on the paper liner for 2 seconds. Repeat until entire surface is bonded. Allow to cool.
  4. Peel off paper liner.
  5. Place material, adhesive side down, on top of project.
    Press iron on fabric with firm pressure for 8 seconds on each section until entire piece is bonded.

    Times listed above are for cotton. For thicker fabrics, additional time may be required.
    DO NOT SEW! If stitching is required, use HeatnBond Lite in the purple package.

Tips

  • Pre-wash all materials without fabric softeners. Pretest adhesive on materials before starting project.
  • Do not touch iron directly to the adhesive sheet. 
  • Machine wash warm and dry on low heat or no heat (and in accordance to garment (fabric) washing directions). Avoid repeated or excessive ironing to the area after fusing.
BACK TO TOP