Therm O Web HeatnBond Soft Stretch Lite Iron-On Adhesive Tape, 5/8 in x 10 yds 3536
Therm O Web HeatnBond Soft Stretch Lite Iron-On Adhesive Tape, 5/8 in x 10 yds 3536
Therm O Web HeatnBond Soft Stretch Lite Iron-On Adhesive Tape, 5/8 in x 10 yds 3536
  • SKU: 3536
  • Availability: in stock Many in stock Out of stock You can purchase this product but it's out of stock

HeatnBond Soft Stretch Lite Iron-On Adhesive Tape, 5/8 in x 10 yds

$3.49
  • Barcode: 000943035367
HeatnBond Soft Stretch Lite is a sewable, lightweight iron-on web adhesive specially designed to move with your stretch fabric while maintaining a strong bond! There is no added bulk and maintains a soft hand after fusing. Great to use with knits, stretch denim, spandex, jersey fabrics, fleece and flannel.

Product Details

  • 5/8 inch x 10 yards tape (15.9 mm x 9.1 m)
  • Permanent and sewable double-sided iron-on adhesive
  • Designed for stretch fabrics
  • Saves time by eliminating pinning
  • Doesn’t gum up needles

Video

General Directions

  1. Pre-wash all materials without fabric softeners. Pretest adhesive on materials before starting project. 
  2. Preheat iron to high heat, no steam.
  3. Place web adhesive on the wrong side of the fabric to be bonded (paper liner should face up).
  4. Place and hold iron on the paper liner for 5 Seconds. Repeat until entire surface is bonded. Allow to cool. Peel off paper liner.
  5. Place material, web adhesive side down, on top of project. With steam, Press and hold iron for 20 Seconds on each section until entire piece is bonded.
  6. Machine or hand sew as desired.

Tips

  • Pre-wash all materials without fabric softener. Pretest adhesive on materials before starting project.
  • Iron fabrics prior to applying Soft Stretch Lite
  • Do not touch iron directly to the adhesive. Do not iron directly to your ironing board.
  • Machine wash cold delicate cycle and tumble dry on low heat or no heat (and in accordance to garment / fabric washing directions). Dry Cleanable. Avoid repeated or excessive ironing to the area after fusing
BACK TO TOP